Owner's Manual

FOR ACOUSTICALLY SEALING TRANSDUCER RINGS 1.
Separate J the three pieces of Foam (101, 102, 103)
PATENT #8739921 : / >·. .. . 2.
Clean the back panel of the door, remove the backing paper from 1 03 and adhere
directly behind the speaker to the outermost panel
in the door. This will help absorb
. .. ..
601 .//··
1o3 ~"\ , C.,)/'.· ..
~ :····. :)
101 .· · ~IJ!
- -~~102
· .. ~ 400
.
. 602
·. \.
····- ...... ·- .... .. ' ....
600
the rear WaVe and reduce panel Vibration. (This step is optional as it is possible to absorb moisture)
3. With a razor blade cut circumferentially 102 down to approximately 1/4". Remove
backing paper and adhere to mounting surface of speaker. This will decouple the
speaker from its substrate and prevent front and rear wave cancellation.
4. Using standard installation procedures wire and mount speaker.
5. Clean around the outside edge of the speaker, remove the backing paper from 101
and adhere 101 directly around the speaker. Test fit panel for fitment. If needed
trim
101 circumferentially until proper fitment is achieved. It should press tightly to
the door panel. ·This will focus all the sound into the cabin, prevent panel vibration
and destructive wave interference giving you noticeably improved speaker perform-
ance and less panel resonance.
F.A.S.TS