Owner manual

p16
© Fast & Fluid Management, AT550
Troubleshooting
A - Introduction
Before calling your machine supplier or Service Department, please check whether you can solve the problem
yourself. If you cannot, then call the Service Department for advice. Have the model number and serial number
at hand (these can be found on the silver CE sticker at the service panel at the back of the m achine).
Use the Problem Solving chart below to judge whether you can solve a problem yourself or not. The tool symbol
( ) means you cannot solve the problem yourself and the Service Department must be called. On no occasion
remove side panels yourself, this may only be done by trained service personnel. This chart does not inc lude
any of the malfunctions which are reported in an error message by the software. In the event of a m alfunction,
these messages and possible solutions are displayed on the monitor.
Attention! MOVING PARTS CAN CAUSE INJURY. Always turn off power
before accessing moving parts.
B - Service Department
If necessary, you can get in touch with your supplier or the local service department, or contact the
manufacturer directly. If you contact the manufacturer, make sure that you have the model number and serial
number to hand. They can be found on the name plate on the back of the machine.
Fast & Fluid Management
P.O. Box 220
2170 AE Sassenheim, the Netherlands
Hub van Doorneweg 31
2171 KZ Sassenheim, the Netherlands
Tel: [phone]
Fax: [phone] (service)
[phone] (general)
C - Replace fuses
>
Spare fuse Defect