Installation Guide

318267-1
FAST 2K™ DECK POST ANCHOR
Installation Instructions
January 2021
North America
H.B. Fuller | Royal Adhesives & Sealants Canada Ltd
266 Humberline Drive | Toronto, Ontario, Canada M9W 5X1
Tel. [phone] | Fax: [phone] | hbfuller.com
fast2k.com
When installing posts using drums of Fast 2K™ Deck Post Anchor
a. Prepare all holes.
b. Refer to dispensing pump instructions to ensure it is in good working conditioning. Attach air and material feed lines.
Set the timer to the applicable volume output. Open all operating valves.
c. Attach static mixer to the manifold.
d. Aim static mixer at point of installation.
e. Open the wand valve, pull the trigger and pump Fast 2K™ Deck Post Anchor into hole.
f. Once pump automatically stops, close the wand valve and move to the next hole.
IF BREAKS IN DISPENSING EXCEED 30 SECONDS, ATTACH A NEW STATIC MIXER
g. Once all installations are complete, close wand value, remove static mixer and follow pump shutdown procedures.
CLEAN UP
Fast 2K™ Deck Post Anchor can only be mechanically removed after the product cures – clean while wet. Use of a cloth wetted with mineral
spirits can assist in removing Fast 2K™ Deck Post Anchor before it hardens. Should Fast 2K™ Deck Post Anchor get on your skin,
wipe it off as best as possible, then wash the area immediately when the product is still wet.
STORAGE, HANDLING & DISPOSAL
Fast 2K™ Deck Post Anchor should be stored in a cool place. Fast 2K™ Deck Post Anchor is freeze-thaw stable, so exposure to freezing
conditions is acceptable. Prior to use Fast 2K™ Deck Post Anchor should be conditioned to between 65° to 85°F (18°C to 27°C)
for 1-2 hours prior to use.
For safe use and disposal, please refer to the Safety Data Sheet. Disposal should be in accordance with Local, Provincial and Federal
regulations for environmental protection for non-hazardous solid waste. For unused or expired material, completely mix the 2 components
together and dispose as non-hazardous waste after product has cured.