Instruction Manual

C. Route wire harness along frame to the approximate mounting location near the fuel tank. Completion
of this step will be addressed in the Step 3.
B. Secure Relay in an upright position, as shown, to prevent moisture from entering. Di-electric grease
may be applied to prevent corrosion. Examples of locations to secure relay:
A. Using ring terminals, attach red wire of the WH-1004 to the positive
battery terminal. Attach green wire to a clean ground, preferably the
negative battery terminal. Secure fuse block in a location protected
from outside elements. The use of corrosion preventative spray is
recommended.
The installation of the electrical harness is done first, allowing power to be applied to the pump for
lubrication purposes later in the installation.
Note: The FASS harness provided has a 15 amp fuse and the 30 amp fuse provided
loose in the kit is to be installed on the wiring harness due to the volume and torque
the FASS pump is producing.