Use And Care Manual

Can the ceiling tiles be cleaned?
Once you have your ceiling installed, the tiles can be cleaned with warm soapy water. Any harsh abrasives or chemicals
will damage the finish on the tiles.
What tools will I need to install the ceiling tiles?
To install your ceiling panels, you will need the following:
 Tape Measure
 Tin Snips or Scissors
 Caulking gun or 1/4″-notched trowel
 Utility Knife
 Steel Straight Edge
 Adhesive (Loctite PL Premium)
 Permanent Marker
During the installation of my ceiling, some of the adhesive dried on the finish side of my
panels. How can I remove that?
If some of the adhesive has dried on the finish side of the panels, you can use mineral spirits to remove it. This is the
only solvent that can be used that will not damage the finish on the tile. It is best to remove any excess adhesive
immediately using a damp cloth. Allowing excess adhesive to dry on the finished side of the panel may harm the finish.
Can I nail-up the ‘glue-up’ ceiling panels?
Yes, as long as you are using the glue-up ceiling tiles you are able to use finishing nails. We recommend spacing the nails
every 6 inches to avoid a ripple effect. Please note that the nails will be more noticeable when used with certain styles
and finishes.