Use and Care Manual

Use and Care Instructions for Backsplash Panels
How do I need to prepare the wall before I install backsplash?
The wall to which you plan to install backsplash panels to needs to be freshly cleaned, free from dust, grease,
wax, etc. After you’ve cleaned the wall, be sure that it is dried thoroughly. See our Fasade Backsplash
Installation Guide for more information.
What can I use to cut the backsplash panels?
To cut the backsplash panels, you can use a utility knife, scissors or a tin snips.
What kind of adhesive can I use to install backsplash?
There are two different types of adhesive you can use to install the backsplash panels. The first type is to use a
notched trowel (1/4" x 1/4" x 3/4") and apply the adhesive directly to the backsplash. ACP, the manufacturer
of Fasade, recommends using Loctite® PL Premium®. The second type of adhesive that can be used is a High-
Bond Double-Sided Tape. This is applied in strips to the wall or the back of the panel. See our Fasade
Backsplash Installation Guide for more information..
If I choose to use the Tube Adhesive, how much do I need to purchase?
If using the tube adhesive to install the backsplash panels, one 10.5-ounce size tube covers 3 or 4 backsplash
panels, depending on how much adhesive you apply. Be sure to carefully read the instructions on the back of
the adhesive tube.
Are there accessories for Fasade Backsplash?
Yes, there are Accessory Kits that are available. They are not required to finish your backsplash project, but do
give it a finished look. Accessory kits include four (4) 4-foot J-Trim pieces, one (1) 4-foot Inside Corner Trim
piece and one pack of Outlet Covers (Outlet covers do not come in the white kits.) Kits are available with or
without Double-Sided Adhesive Tape.