User Guide

Q3. I turned off the student computer using the VirtualClass teacher program. Why does the
Scandisk program always run on the next system startup?
Not all of the programs were closed properly when VirtualClass shut down the student systems. Please close all
of the running programs prior to restarting or shutting down.
Q4. I reinstalled the VirtualClass teacher program on my computer. Why did the student number
change?
If you want to keep the student number listing the same as before, please do the following:
1. Select “Save student list” when removing the VirtualClass teacher program.
OR
2. Back up the student list by saving the vclass.vcm from %InstallDir% Program
Files/FarStone/VirtualClass/vclass.vcm. Replace this file after VirtualClass has been reinstalled.
Q5. When should the student log in to the classroom manually?
If the classroom is already online but the student cannot find the classroom in the teacher list, you can enter
the teacher computer name or IP address to log in to this classroom.
Q6. Can I change the language displayed in VirtualClass without reinstalling the program?
Yes. You need to copy the ResXXXX.ini file, which is located in the VirtualClass program folder (number in folder
name indicates certain language, as is shown in the table below) into
%InstallDir%ProgramFiles\FarStone\VirtualClass\Language.
After copying the file, please restart VirtualClass to have the changes take effect after copying the file.
Language Folder for language
Traditional CHINESE 404
Simplify CHINESE 804
ENGLISH 409
FRENCH 40c
GERMAN 407
ITALIAN 410
SPANISH 40a
DUTCH 413
KOREAN 412
JAPANESE 411
Q7. Can I broadcast movies to student computers using VirtualClass?
Yes. You can do this using the NetMovie feature.
Q8. During installation, I received the following error message “1607: Can’t install InstallShield
49