User Guide

In RITN Administrator Options, you can configure the listen port of RestoreIT Network, set an
administrator password; set refresh time span and log file size.
To configure RITN Administrator options:
Select Tools Æ Options from the RITN Administrator menu bar.
The Options dialog box should display (shown below).
Here are detailed instructions on to choose these options:
Port Settings
Under connections, set the working port for RITN Administrator to listen. Normally, the port
should be set between 1024 to 65535.
Administrator Password Settings
The administrator password is required each time when launching RITN Administrator and
when entering a Pre-OS mode to restore the computer.
The password is set at the first time when launching RITN Client after installation. You can
change it any time in this Options dialog box. Click Set Password to change it.
The password consists of English characters and number. The length should between 1 to 32
characters. Note: English characters are case sensitive.
Log File Size
Specify a file size (at least 50KB) to limit the log file of each client to this size. Once the
maximum size is reached, the previous logs will be automatically cleared.
Refresh Time
RITN Administrator and RITN Client send messages to each other in real time. When a
message cannot be sent, RestoreIT Network will try to re-send the message according to the
refresh time you set here. The number should be set between 1 to 120.
- 26 -