User Guide

3-6.3 RITN Client Function Control
RestoreIT Network allows the network administrator to disable incremental and file-level functions on
RITN Client, so that client user cannot manual create/restore an IBP, configure file backup settings
or restore files. It also allows the administrator to hide the RITN Client interface to prevent any
manual operations on the client side.
To control RITN Client functions:
Select a client or a group from the left panel of the RITN Administrator main interface.
Note:
This operation will take effect for both online and offline clients.
Choose Settings from the function panel in the upper right of RITN Administrator main interface.
The lower part of this page is the client interface and function control options. (shown below)
Here is a detailed instruction on to choose these options:
z Show Client User Interface
If this box is checked, the RITN Client user interface can be open on client side. Client users
can perform all allowed functions from this interface. If this box is cleared, the RITN Client
interface cannot open and all functions cannot be used. The following options should be
grayed and unable to be selected.
◊ Incremental Backup
Note: These options are available only when the Enable Incremental Backup box under
Backup in this page is checked.
Allow to create Incremental Backup Point
If this box is checked, users can create an IBP from RITN Client interface.
Allow to restore ibp
If this box is checked, users can restore an IBP from RITN Client interface.
◊ File-Level Backup
Note: These options are available only when the Enable Incremental Backup box under
Backup in this page is checked.
Allow to configure File-Level Backup settings
If this box is checked, users can specify files to back up from RITN Client interface.
Allow to restore files
If this box is checked, users can perform a File-Level Restore from the RITN Client
interface.
After you have made your selection, click Apply to activate your settings. If the settings are
successfully applied, the Apply button will change to gray.
3-7 RITN Administrator Options
- 25 -