User Guide

To disable/enable incremental backup:

1. Select a client or a group from the left panel of the RITN Administrator main interface.

Note:

This operation will take effect for both online and offline clients.

2. Choose Settings from the function panel in the upper right of the RITN Administrator main

interface.

3. Check the Enable Incremental Backup box under Backup.

4. Click Apply to activate the settings. If the settings are successfully applied, the Apply button will

change to gray.

3-6.2 Enabling/Disabling File-level Backup

File-Level Backup feature backs up previous versions of a specific file on the client computer after it

has been deleted, changed or overwritten. It allows clients to restore individual files without having

to restore the entire system to an earlier point in time.

Configuring files to back up and the operation of restoring files should be done on

RITN Client, but the

ability to configure file-level backup settings and to restore files should be authorized by the network

administrator from the RITN Administrator.

Normally file-level backup should be enabled to ensure clients’ files get continuous protection, but in

some cases you may need to disable the feature for some clients temporarily.

Once the file-level backup feature is disabled:

Client user cannot configure file backup settings or restore any files; (The File-Level Backup

functions is disabled in the RITN Client interface)

All existing file backup tasks of the executed client will stop working;

All previously created file backups still exist in the RestoreIT Secure Area on the client computer, but

will not be able to use for restoration until this feature is re-enabled;

To disable/enable File-level backup: