User's Manual

Pyramid Series Proximity Readers
2177 Leghorn Street 01566-002 Rev. 1.2
Mountain View, CA 94043-1605 USA Page 12 of 22
Tel: [phone] Fax: [phone]
Web: http://www.pyramidseries.com E-mail: [e-mail]
Product ManualPyramid Series
3.6 Installing the Front Cover Bezel
Once the electronics package is installed, simply align one corner of the front cover bezel
with the mounted package and gently press it into place. To remove the front cover bezel,
slip a thin blade screwdriver just inside the bezel (see the location identified in Figures 1,
3, 4, and 5 for the reader being installed
1
). Gently twist the screwdriver to pop the front
cover bezel loose – using excessive force when removing the front cover bezel can
damage the reader's LED.
3.7 Wiring Connections
Refer to Figures 6, 7, and 8 for instructions for wiring a Pyramid Reader
2
to either a
Wiegand compatible access panel or a Magnetic Stripe compatible access panel
3
.
NOTE: As shown in Figures 6, 7, and 8, the shield and ground must be tied together at
the access panel. Never tie the shield and ground together at the reader.
Figure 6: : Wiegand Format Reader Wiring Connections
1. The P-400 Gibraltar Reader does not have a front bezel to maximize its vandal resistance.
2. For Beeper and LED operation information, see section 4.3 Controls
on page 14.
3. The magnetic stripe output data configuration is open collector.