User's Manual

Kovera Demo Program User’s Guide
e-mail:[e-mail] 2 of 5
web: www.farpointedata.com
Program Details
When the program is run for the first time, there are a few items that need to be set up.
1. Select the correct serial port. This is chosen under the “Reader Serial” field
when the program begins. The number will depend on which serial port your
reader is connected to. If the program does not detect a functioning reader
on the port selected, an error message will result. If this is the case, a
different serial port must be selected. The program will not continue until it
finds a reader connected to the selected serial port.
2. To run the Demonstration program, select the Demo Program button. For
more information about the Utility Mode, see the extensive Online Help.
The next step is to choose the “Tag Type”. The type of tag that will be used
must be highlighted for the Demonstration to work properly; otherwise the
reader might be unable to recognize a tag when it is presented.
The initial “Tag Type” selected is obtained from the reader and matches its
current configuration. If the same type of tag is always used, the “Tag Type”
should not change and does not need to be reconfigured each time the
program is restarted.
Click on
Demo
Program
Kovera Reader default address is 0 on power-up
Choose
correct serial
port