User's Manual
Table Of Contents
- _
- _
- How to use the guide
- Safety Messages (review carefully)
- HDP100 Overview
- Safety Messages (review carefully)
- Introduction
- Reviewing the HDP100 Printer Overview table
- Regulatory Compliances, Agency Listings and FCC Rules
- Regulatory Compliances
- Agency Listings
- Technical Specifications
- Functional Specifications
- Reviewing the Overlaminates
- LCD Messages
- Troubleshooting LCD Messages
- Communications Errors
- Card Feeding Errors
- Magnetic Encoding Errors
- E-card Encoding Errors
- Film Errors
- Printing Process Errors
- Card Lamination Errors
- Printing a Test Image
- _
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
54
Resolving a Ribbon Sensor Error (Ribbon Miscue)
Step Procedure
2 Open the front Cover and remove the Ribbon.
a. Check that the Ribbon is in good condition and not wrinkled or broken.
b. If Ribbon is broke or wrinkled, repair the Ribbon and wind up the take-
up roll 4-color panels past the damaged area.
3
Press on the Resume button.
If the issue persists, continue to Step 4.
4 Replace the Ribbon.
a. Press on the Resume button.
b. If the issue persists, continue to Step 5.
5
Press the Cancel Print button on the Driver Monitor Error Display
Message.
6 Reboot the Printer by cycling the power.
7 Using the driver calibration tab calibrate the Ribbon Sensor.
If the issue persists, continue to Step 8.
8 Replace the Ribbon Sensor.