User's Manual
Table Of Contents
- _
- _
- How to use the guide
- Safety Messages (review carefully)
- HDP100 Overview
- Safety Messages (review carefully)
- Introduction
- Reviewing the HDP100 Printer Overview table
- Regulatory Compliances, Agency Listings and FCC Rules
- Regulatory Compliances
- Agency Listings
- Technical Specifications
- Functional Specifications
- Reviewing the Overlaminates
- LCD Messages
- Troubleshooting LCD Messages
- Communications Errors
- Card Feeding Errors
- Magnetic Encoding Errors
- E-card Encoding Errors
- Film Errors
- Printing Process Errors
- Card Lamination Errors
- Printing a Test Image
- _
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
37
Resolving a Card Jam (Laminator) Error
Step Procedure
3 Test the Card Detection Sensor (D840624).
a. Remove the rear Cover.
b. Using a Digital voltmeter, connect the negative lead to ground.
c. Connect the positive lead to Pin 1 of J6.
If blocked, the voltage should read 4.9 to 5.5 VDC.
If unblocked, the Sensor should read 0.15 to 0.18 VDC.
d. If the voltages do not read correctly, replace the Sensor.