User's Manual
Table Of Contents
- _
- _
- How to use the guide
- Safety Messages (review carefully)
- HDP100 Overview
- Safety Messages (review carefully)
- Introduction
- Reviewing the HDP100 Printer Overview table
- Regulatory Compliances, Agency Listings and FCC Rules
- Regulatory Compliances
- Agency Listings
- Technical Specifications
- Functional Specifications
- Reviewing the Overlaminates
- LCD Messages
- Troubleshooting LCD Messages
- Communications Errors
- Card Feeding Errors
- Magnetic Encoding Errors
- E-card Encoding Errors
- Film Errors
- Printing Process Errors
- Card Lamination Errors
- Printing a Test Image
- _
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
19
Magnetic and E-card Troubleshooting Guide
Problem Possible Solution
Film is only printing
on the back half of
the card
Check to see if the Lamination Lift Motor (D840980) is rotating in
the correct direction.
Start Sentinel is
yellow or red
Change the magnetic TOF in the LCD according to the start
sentinel reference chart
Verify correct mag Module placement. The mag Module should be
adjusted so that the belt (F000111) is snug prior to installing the
tensioner.
Verify correct tension of the belt (F000111). Belt should have
approximately 1/8 deflection at the center point between pulleys