User's Manual
Table Of Contents
- _
- _
- How to use the guide
- Safety Messages (review carefully)
- HDP100 Overview
- Safety Messages (review carefully)
- Introduction
- Reviewing the HDP100 Printer Overview table
- Regulatory Compliances, Agency Listings and FCC Rules
- Regulatory Compliances
- Agency Listings
- Technical Specifications
- Functional Specifications
- Reviewing the Overlaminates
- LCD Messages
- Troubleshooting LCD Messages
- Communications Errors
- Card Feeding Errors
- Magnetic Encoding Errors
- E-card Encoding Errors
- Film Errors
- Printing Process Errors
- Card Lamination Errors
- Printing a Test Image
- _
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
18
General Troubleshooting Guide (continued)
Problem Possible Solution
Dash Lines on Image
Check the Transfer Roller (D880146) or Platen Roller (D860022)
for cuts or nicks.
Film Sensor Error Verify the Film Sensors (J35 and J36) have not been switched.
CHECK FOR ACCURACY
Verify the Take-up Motor turns without delay when Lamination
begins. Increase the transfer tension if the Motor delays.
Verify that the washers (760386) are between the e-clip and
springs on the spring loaded film and Ribbon hubs.
Verify the film is not telescoped on the roll with fixture TL1574.
Verify the Platen Roller stepper Motor cable (D860120) is wired
correctly and is connected to the Motor (E000062) and the
circuit Board (A000300) J32.
Ribbon Sticking to
the Film
Increase the Ribbon Tension. See the Adjusting the Ribbon
Tension procedure.
Continued on the next page