User's Manual
Table Of Contents
- _
- _
- How to use the guide
- Safety Messages (review carefully)
- HDP100 Overview
- Safety Messages (review carefully)
- Introduction
- Reviewing the HDP100 Printer Overview table
- Regulatory Compliances, Agency Listings and FCC Rules
- Regulatory Compliances
- Agency Listings
- Technical Specifications
- Functional Specifications
- Reviewing the Overlaminates
- LCD Messages
- Troubleshooting LCD Messages
- Communications Errors
- Card Feeding Errors
- Magnetic Encoding Errors
- E-card Encoding Errors
- Film Errors
- Printing Process Errors
- Card Lamination Errors
- Printing a Test Image
- _
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
13
Troubleshooting the LCD Messages
LCD Message Cause Solution
UTILITY ERROR Command resulted in an
error.
See Resolving the Communication
Errors.
Wrong Film The Printer was unable to
sense the HDP Film
properly while printing.
OR
The Printer senses that
the wrong HDP Film had
been installed.
If this appears as an error, see
Resolving a Film Sensor Not
Calibrated Error.
WRONG RIBBON The print Ribbon installed
in the Printer does not
match the Ribbon type
selected in the Printer
Driver.
OR
A Self-test job cannot be
printed with the print
media installed or the
Ribbon must contain
YMC panels for Sensor
calibration.
Change either accordingly. Press
RESUME to continue or CANCEL
to abort.
See Resolving a Wrong Ribbon
Error.
Ribbon Wrinkle Verify the convex Roller
(D860051) is installed
correctly with the shorter
notch towards the front of
the Printer.
Verify the density is set
within specification (67-
69).
Check to see if the Ribbon Hubs are
too tight.
Check the Printhead alignment. See
the Setting the Printhead
Resistance procedure.
Continued on the next page