User's Manual
Table Of Contents
- _
- _
- How to use the guide
- Safety Messages (review carefully)
- HDP100 Overview
- Safety Messages (review carefully)
- Introduction
- Reviewing the HDP100 Printer Overview table
- Regulatory Compliances, Agency Listings and FCC Rules
- Regulatory Compliances
- Agency Listings
- Technical Specifications
- Functional Specifications
- Reviewing the Overlaminates
- LCD Messages
- Troubleshooting LCD Messages
- Communications Errors
- Card Feeding Errors
- Magnetic Encoding Errors
- E-card Encoding Errors
- Film Errors
- Printing Process Errors
- Card Lamination Errors
- Printing a Test Image
- _
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
11
Troubleshooting the LCD Messages (continued)
LCD Message Cause Solution
Ribbon Break/Jam The print Ribbon is either
jammed or broken.
If jammed, see Resolving a
Ribbon Break/Jam Error. If
broken repair by taping the
Ribbon back on to the take-up
core. Press RESUME to continue
or CANCEL to abort.
RIBBON TENSION The Ribbon tensions or
pretensions may be out
of range.
Check and adjust the LCD
settings. If this problem persists,
call for technical assistance.
Press RESUME to continue or
CANCEL to abort.
Remove Ribbon The print Ribbon is either
damaged or the Printer is
not calibrated.
Replace the Ribbon or
recalibrate. See Resolving a
Ribbon Break/Jam Error. Press
RESUME to continue or CANCEL
to abort.
Self Test Fault Self-test job could not be
initiated.
Reset the Printer and try again. If
this problem persists, call for
technical assistance. See Printing
a Test Image.
Continued on the next page