User's Manual
Table Of Contents
- _
- _
- How to use the guide
- Safety Messages (review carefully)
- HDP100 Overview
- Safety Messages (review carefully)
- Introduction
- Reviewing the HDP100 Printer Overview table
- Regulatory Compliances, Agency Listings and FCC Rules
- Regulatory Compliances
- Agency Listings
- Technical Specifications
- Functional Specifications
- Reviewing the Overlaminates
- LCD Messages
- Troubleshooting LCD Messages
- Communications Errors
- Card Feeding Errors
- Magnetic Encoding Errors
- E-card Encoding Errors
- Film Errors
- Printing Process Errors
- Card Lamination Errors
- Printing a Test Image
- _
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
9
Troubleshooting the LCD Messages (continued)
LCD Message Cause Solution
Mag Verify Error Print could not verify
MAG write.
OR
The magnetic stripe was
not encoded properly.
See Resolving a Magnetic Verify
Error.
MULTIPLE FEED Two or more cards fed
from the Card Hopper.
See Resolving a Card Not Fed
Error.
No Flip Module Two sided job sent to a
one sided Printer.
See a No Flipper Table Module
Error.
No Prox Encoder You are trying to send
encoding data, but the
Printer is not configured
with this Encoder type.
See Resolving a No Prox Card
Encoder Error.
Continued on the next page