User's Manual
Table Of Contents
- _
- _
- How to use the guide
- Safety Messages (review carefully)
- HDP100 Overview
- Safety Messages (review carefully)
- Introduction
- Reviewing the HDP100 Printer Overview table
- Regulatory Compliances, Agency Listings and FCC Rules
- Regulatory Compliances
- Agency Listings
- Technical Specifications
- Functional Specifications
- Reviewing the Overlaminates
- LCD Messages
- Troubleshooting LCD Messages
- Communications Errors
- Card Feeding Errors
- Magnetic Encoding Errors
- E-card Encoding Errors
- Film Errors
- Printing Process Errors
- Card Lamination Errors
- Printing a Test Image
- _
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
8
Troubleshooting the LCD Messages (continued)
LCD Message Cause Solution
LAM LIFT ERROR See the next column. If this problem persists, call for
technical assistance.
CHECK LAM
MATERIAL
Lamination material is
low.
See Resolving Check Lamination
Material Error.
LAM MEMORY
ERROR
See the next column. If this problem persists, call for
technical assistance.
MAG ENCODING The magnetic stripe was
not encoded properly.
See Resolving a No Magnetic
Strip Present Error.
Magnetics: The Magnetic Encoder
was properly installed.
No action required.
MAG ENCODER
PAUSED
The head arm assembly
has been opened during
Magnetic Encoding,
causing this operation to
halt.
Press RESUME to retry or
CANCEL to abort. See Magnetic
Encoding Errors.
MAG ENCODER
STARTUP ERROR
A problem has been
detected in the MAG
encoding section of the
Printer during start-up.
If this problem persists, call for
technical assistance. See
Magnetic Encoding Errors.
Continued on the next page