User's Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
7
Troubleshooting the LCD Messages (continued)
LCD Message Cause Solution
Lamination A power connector must
be connected to the
Laminator module.
Insert power connector and cycle
power to the Printer. See
Resolving the Laminator (Check
Power) Error.
Lam Card Jam A card is jammed in the
Lamination module area
of the Printer.
Clear the jam. See Resolving a
Card Jam (Laminator) Error.
Press QUIT to clear this
message.
LAM CARD FLIP
ERROR
A problem has been
detected in the Laminator
Flipper.
If this problem persists, call for
technical assistance. See
Resolving a Card Jam
(Laminator) Error.
LAM ERROR The Lamination module
requires attention.
Check the indicated condition and
correct it, using the Laminator's
control buttons. Press QUIT to
clear this message.
See Resolving a Laminator
(General Error).
LAM HANDLER
STARTUP ERROR
See the next column. If this problem persists, call for
technical assistance. See
Resolving the Laminator (Check
Power) Error.
Lam Heat Timeout The Transfer Roller was
unable to reach its goal
temperature.
Reboot the Printer and try
sending the print job again. If this
problem persists, call for technical
assistance. See Resolving LAM
Heater Times Out Error.
LAM HEATER OFF See Resolving LAM Heater Times
Out Error.
Continued on the next page