User's Manual
Table Of Contents
- _
- _
- How to use the guide
- Safety Messages (review carefully)
- HDP100 Overview
- Safety Messages (review carefully)
- Introduction
- Reviewing the HDP100 Printer Overview table
- Regulatory Compliances, Agency Listings and FCC Rules
- Regulatory Compliances
- Agency Listings
- Technical Specifications
- Functional Specifications
- Reviewing the Overlaminates
- LCD Messages
- Troubleshooting LCD Messages
- Communications Errors
- Card Feeding Errors
- Magnetic Encoding Errors
- E-card Encoding Errors
- Film Errors
- Printing Process Errors
- Card Lamination Errors
- Printing a Test Image
- _
RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
6
Troubleshooting the LCD Messages (continued)
LCD Message Cause Solution
Invalid Film The Printer was unable to
sense the HDP Film
properly while printing.
OR
The Printer senses that
the wrong HDP Film had
been installed.
See Film Errors procedure.
INVALID
PASSWORD
Printing disabled at this
time.
Press CANCEL to abort this print
job and then check security settings
at host computer.
INVALID RIBBON The print Ribbon installed
in the Printer does not
match the Ribbon type
set in the Printer.
Get the correct Ribbon from your
dealer. See Resolving an Invalid
Ribbon Error.
Init Indicates the Printer is
beginning its startup
system check. Referred
to as initializing.
PLEASE INSERT
RIBBON
Instructs the User to
properly insert the
Ribbon in the Printer.
Same as the cause.
JOB DATA ERROR
The print data sent to the
Printer is corrupt or has
been interrupted.
OR
The Feed Module is out
of sequence with the
Transfer section.
Check the interface cable and
cancel the print job from the PC.
Press CANCEL to abort this print
job and then resend the job.
See Resolving the Communication
Errors.
Continued on the next page