User's Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
4
Troubleshooting the LCD Messages (continued)
LCD Message Cause Solution
Empty Indicates no cards or
empty.
Refill.
FILM OUT The HDP Film has run
out.
OR
The HDP Film will soon
run out.
Install a new roll of film and press
RESUME to continue or CANCEL
to reset.
If this appears as an error, see
Resolving a Film Out Error.
Flipper Jam A card is jammed in the
card flipping area of the
Printer.
Clear the jam. See Flipper Jam
Error procedure.
Film Align Error Unable to align film.
OR
If this appears as a
prompt, the HDP Film
is self-aligning to the
proper position for
printing.
Check for obstruction. If the
problem persists, call for technical
assistance. If this appears as an
error, see Film Errors procedure.
Film Break/Jam
FILM LOW
FILM RELEASE
FILM RELEASE
ERROR
The HDP Film is not
installed properly or
has run out, jammed,
broken or been
damaged.
If this appears as an error, see
Film Errors or Resolving a Film
Out Error.
Film: Wrong Material The HDP Film is not
installed properly or
has run out, jammed,
broken or been
damaged.
If this appears as an error, see
Film Errors or Resolving a Film
Out Error.
Continued on the next page