User's Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
HDP100 High Definition Card Printer/Encoder User Guide (Rev. Beta)
iv
Resolving a Card Eject Error _________________________________________________________38
Resolving a No Flipper Table Module Error _____________________________________________39
Resolving a Flipper Jam Error ________________________________________________________40
Magnetic Encoding Errors______________________________________________________________42
Resolving a Magnetic Verify Error ____________________________________________________42
Resolving a No Magnetic Encoder Installed Error_________________________________________45
Resolving a No Magnetic Strip Present Error_____________________________________________47
E-card Encoding Errors________________________________________________________________48
Resolving a No Smart Card Encoder Error_______________________________________________48
Resolving a No Prox Card Encoder Error _______________________________________________49
Film Errors _________________________________________________________________________50
Resolving a Film Not Installed Error ___________________________________________________50
Resolving a Film Sensor Not Calibrated Error____________________________________________51
Resolving a Film Out Error __________________________________________________________52
Printing Process Errors ________________________________________________________________53
Resolving a Ribbon Sensor Error (Ribbon Miscue) ________________________________________53
Resolving a Ribbon Break/Jam Error___________________________________________________55
Resolving a Ribbon Out Error ________________________________________________________57
Resolving a No Ribbon Installed Error__________________________________________________58
Resolving a Invalid Ribbon Error______________________________________________________60
Resolving a Wrong Ribbon Error______________________________________________________62
Resolving a Headlift Motor or Sensor Error______________________________________________64
Resolving the Cover Open Error Message _______________________________________________66
Resolving the Blank Output issues _____________________________________________________68
Card Lamination Errors________________________________________________________________71
Resolving a Laminator (General Error) _________________________________________________71
Resolving the Laminator (Check Power) Error ___________________________________________72
Resolving the Laminator (Heater Off) Error _____________________________________________73
Resolving the Wrong Overlaminate Installed Error ________________________________________74
Resolving Check Lamination Material Error _____________________________________________75
Resolving LAM Heater Times Out Error ________________________________________________76
Printing a Test Image _________________________________________________________________77
Reviewing the Gray/Align YMC/K Self-Test ____________________________________________77
Reviewing the Color/Resin YMCK Self-Test ____________________________________________78
Reviewing the Color Bars YMC Self-Test_______________________________________________78
Reviewing the Card Count Self-Test ___________________________________________________79
Reviewing the Magnetic Test option ___________________________________________________79
Reviewing the Lamination Color/Resin YMCK+L Self-Test ________________________________80