User manual
Installation 9
S/T I
NTERFACE
Outside of North America, ISDN connections are made using the S/T
interface. Plug the RJ-45 cable into your ISDN wall jack. Then connect
the cable to the RJ-45 port on the S/T interface connector.
Connecting the S/T interface connector and RJ-45 cable
In Australia, a different S/T interface is used, and a terminating
resistor may be required. The illustration below shows how the
Australian ISDN S/T interface connector, the terminating resistor, and
the RJ-45 cable connect together. For more information about
terminating resistors, see the README.TXT file on the Netopia ISDN
PC Card Disk 1.
Connecting the S/T interface connector, terminating resistor, and RJ-45 cable