Installing the faucet assembly Shut off the water supply. Remove the old faucet. Clean the mounting surface. Remove the reassembled nut (H) and ‘washer (6) from the new faucet (A). Loosen the screws {) on the nut (H} until the ends of the screws {) are flush with the face of the nut (H). Place the faucet (4) through the mounting halos In the sink. Secure the faucet (A) to the sink using the ‘washer (G) and nut (H} provided. Securely tighten the screws (I) on the nut (H} with the Hex wrench (Hex: 2.
Attaching the quick connect hose Attach the quick connect hose (J) connections to the hot faucet handle (B) connection, faucet body (A) connection, and cold faucet handle (C) connection. Push until the connections snap together. Pull down moderately to ensure the connections. have been made, Making the water supply connections Usa 172 In. LP.S. faucet connections (2), or use supply Lina coupling nuts (3} (not Included) with 2.3/8 In. 0.0. lab-noss riser (1).
1 Flushing and checking for leaks o Ensure the faucet {A) handles are In the off position and tum on the wader supply to check for leaks. If you discover any leaks, check your connections to ensure they are Installed properly. o Remove the aerator and housing (if applicable). Tum on the hot and cold handles to allow the ‘water to run for at least one minute. This flushes away any debris that could cause damage fo internal parts. o Tum off the water and reinstall the aerator and housing {if applicable).
