User's Manual
Table Of Contents
- Directory
- 1 Picture
- 2 Table
- 3 Safety Instruction
- 4 Overview
- 5 Install Guide
- 6 Basic Introduction
- 7 Basic Function
- 8 Advance Function
- 9 Web Configurations
- 9.1 Web Page Authentication
- 9.2 System >> Information
- 9.3 System >> Account
- 9.4 System >> Configurations
- 9.5 System >> Upgrade
- 9.6 System >> Auto Provision
- 9.7 System >> FDMS
- 9.8 System >> Tools
- 9.9 Network >> Basic
- 9.10 Network >> VPN
- 9.11 Network >> Web Filter
- 9.12 Line >> SIP
- 9.13 Line >> Basic Settings
- 9.14 Line >> SIP Hotspot
- 9.15 EGS Setting >> Features
- 9.16 EGS Setting & Intercom Setting >> Audio
- 9.17 EGS Setting & Intercom Setting >> Video
- 9.18 EGS Setting & Intercom Setting >> MCAST
- 9.19 EGS Setting & Intercom Setting >> action URL
- 9.20 EGS Setting & Intercom Setting >> Time/Date
- 9.21 EGS Settings >> Trusted Certificates
- 9.22 EGS Settings >> Device Certificates
- 9.23 EGS Access
- 9.24 EGS Logs
- 9.25 Door Lock
- 9.26 Alert &Security Settings
- 9.27 Function Key
- 10Trouble Shooting
51
Duration
Input trigger
When the input port meets the trigger condition, the output port will be triggered
(The Port level time change, By < Output Duration > control)
DTMF output
Duration
By duration
Port switch amount change time, press <output duration>
control
By Calling
State
By call state control, after the end of the call, port to return the
default state
Remote
DTMF trigger
Receive the DTMF password sent by the remote device. If it is correct, trigger
the corresponding output port. You can choose to enable or disable ringtones
DTMF trigger
code
During the call, the receiving terminal device sends a DTMF password, and if it
is correct, the corresponding output port is triggered. The default is 1234.
Remote SMS
trigger
Enable or disable remote SMS triggering. You can choose to enable or disable
ringtones
Trigger
Message
Format
Send instructions on remote devices or servers, ALERT= [set instructions], if
correct, trigger the corresponding port output.
Call status
trigger
The port outputs a continuous time trigger type, including the trigger condition.
For example, the call triggers the output port, and the output port will be in the
call state and continue to respond)
1 Talking
2 Talking and Ringing
3 Ringing
4 Calling
5 Calling and Talking
6 Calling and Ringing
7 Calling, Ringing and Talking
Tamper Alarm Settings
Alarm
command
When detected someone tampering the equipment, the alarm signal will be
sent to the corresponding server
Reset
command
When the equipment receives the command of reset from server, the
equipment will stop alarm
Reset
Alerting
Status
Reset to resume and stop ringtone playback
Ring Type
Ringtone can be set to none / preset
Server Settings
Server
Address
Send message to the server when the alarm is triggered.
message format：Alarm Info: Description=i32V;SIP