User's Manual

35
Effective Data
Wiegand Data
Reverse
Set Wiegand Data Reverse, the default value is automatic.
Enable Access Table
Disable remote password implementations for all calls to open doors;
Enable remote password to open the door after calling only by access
guard
Limit Talk Duration
If enabled, calls would be forced ended after talking time is up.
Talk Duration
The call will be ended automatically when time up. Initial Value is 120
seconds
Calling Password
Remote door unlocking password. Initial Value is “*”.
Description
Device description displayed on IP scanning tool software. Initial Value
is “i32V IP Door Phone”.
Enable Open Log
Server
Enable or disable to connect with log server
Address of Open Log
Server
Log server address(IP or domain name)
Port of Open Log
Server
Log server port (0-65535) , Initial Value is 514.
Door Unlock
Indication
Indication tone for door unlocked. There are 3 type of tone: silent/short
beeps/long beeps.
Remote Code Check
Length
The remote access code length would be restricted with it. If the input
access code length is matched with it, system would check it
immediately. Initial Value is 4.
Basic Settings（Door Phone &Intercom Phone）
DND (Do Not
Disturb)
DND might be disabled phone for all SIP lines, or line for SIP
individually. But the outgoing calls will not be affected
Ban Outgoing
If enabled, no outgoing calls can be made.
Enable Call Waiting
The default value is enabled. Allow users to answer the second call
while maintaining the call.
Enable Call Waiting
Tone
The default value is enabled. When enabled, the call waiting tone can
be heard while waiting for a call. If this function is turned off, when
waiting for a call, the beep will not be heard.
Enable Intercom
Mute
If enabled, mutes incoming calls during an intercom call.
Enable Intercom
Tone
If enabled, plays intercom ring tone to alert to an intercom call.
Enable Auto Dial Out
Enable Auto Dial Out when timeout.
Auto Dial Out Time
Configure waiting time for timeout dialing.