Hotel Phone - H3 & H5 Quick Installation Guide
Connection methods Please connect power adapter, network, PC, and handset to the corresponding ports as described in below picture.
1 Introduction to the Phone User Interface 1.1 Keypad DSS Keys Message waiting / Speaker Incoming call indicator Volume Control key Hold key Mute key Transfer key Speaker key Redial key MWI key The above picture shows the keypad layout of the device. Each key provides its own specific function. User should refer to the illustration in this section about the usage of each key and the description in this document about each function.
2 Phone Settings In order to get the device ready for making and receiving phone calls, the device must be configured with correct network configurations and with an SIP telephony service. The SIP must be configured properly to be able to provide telephony service. 2.1 Getting IP address DHCP is the default setting in Network, and telephone will get the IP address from DHCP server(Router) after the line connected. There are three common IP configuration modes.
2.4 SIP Setting Enter into the web setting interface, select Line->SIP, and fill in the items below. Server Address Account Name Phone Number Password Click the Apply button to save the Configuration, that you can make a call after the SIP registration is successful. 2.5 Memory key setting Enter into the web setting interface, select Function key->Function key. Select the function and fill in the number in the value items.
3 Basic Operation 3.1 Making call There are two ways to make a call, using dial pad or memory button. Lift the handset or press hands-free key. Dial the number on the dial pad or press memory key, end with # as default. End a call, hang up handset. 3.2 Answering call When your telephone rings and the light flashes. Lift the handset or hands-free key and start to talk. End a call, hang up handset. 3.3 Holding call While on a call, press the “Hold” key.
