User's Manual

62
/
125
9.6 MCAST
This feature allows user to make some kind of broadcast call to people who are in multicast group. User can
configure a multicast DSS Key on the phone, which allows user to send a Real Time Transport Protocol (RTP)
stream to the pre-configured multicast address without involving SIP signaling. You can also configure the
phone to receive an RTP stream from pre-configured multicast listening address without involving SIP
signaling. You can specify up to 10 multicast listening addresses.
Picture 72 - Multicast Settings Page
Table 12 - MCAST Parameters on Web
Parameters
Description
Normal Call Priority
Define the priority of the active call, 1 is the highest priority, 10 is the lowest.
Enable Page Priority
The voice call in progress shall take precedence over all incoming paging calls.
Name
Listened multicast server name
Host:port
Listened multicast server’s multicast IP address and port.
Multicast:

Go to web page of [Function Key] >> [Function Key] , select the type to multicast, set the multicast
address, and select the codec.

Click Apply.

Set up the name, host and port of the receiving multicast on the web page of [Phone Settings] >>
[MCAST].

Press the DSSKY of Multicast Key which you set.

Receive end will receive multicast call and play multicast automatically.
9.7 SCA（Shared Call Appearance）
Users need the support of server end to use SCA function.
1) Configure on Phone
 When registering with the BroadSoft server, a Phone can register the account created previously on