User's Manual

110
/
125
Popup
popup prompt when the WIFI adapter is closed. It is on by default.
Display SMS Popup
There is popup prompt for unread messages after opening, and there is
no popup prompt when closing. It is opened by default.
Display Other Popup
When the handle is not hung back after opening, registration fails, IP
acquisition fails, Tr069 connection fails and other abnormalities, there will
be popup prompt when it is opened; otherwise, there will be no prompt
when it is closed, and it will be opened by default.
12.10 Phone settings >> Media Settings
Change voice Settings.
Table 26 - Voice settings
Parameters
Description
Codecs Settings
Select enable or disable voice encoding:
G.711A/U,G.722,G.729, G.726-16,G726-24,G726-32,G.726-40,
ILBC, Opus
Audio Settings
Handset Volume
Set the Handset volume, the value must be 1~9
Default Ring Type
Configure default ringtones. If no special ringtone is set for the phone
number, the default ringtone will be used.
Speakerphone Volume
Set the hands-free volume to 1-9.
Headset Ring Volume
Set the volume of the earphone ringtone to 1~9.
Headset Volume
Set the volume of the headset to 1~9.
Speakerphone Ring
Volume
Set the volume of hands-free ringtone to 1~9.
G.723.1 Bit Rate
5.3kb/s or 6.3kb/s is available.
DTMF Payload Type
Enter the DTMF payload type, the value must be 96~127.
AMR Payload Type
Set AMR load type, range 96~127.
Headset Mic Gain
Set the earphone's radio volume gain to fit different models of earphones.
Opus playload type
Set Opus load type, range 96~127.
OPUS Sample Rate
Set Opus sampling rate, including opus-nb (8KHz) and opus-wb (16KHz).
ILBC Payload Type
Set the ILBC Payload Type, the value must be 96~127.
ILBC Payload Length
Set the ILBC Payload Length
Enable MWI Tone
When there is a new voice message message, the phone will start a
special dial tone.
Enable VAD
Whether voice activity detection is enabled.
Onhook Time
Configure a minimum response time, which defaults to 200ms