PRESSURE WASHER WITH SAND BLAST KIT OWNER'S MANUAL Model VPW40H 120V., 60 Hz., 12.5 Amps. FANTOM 94 Main Mill Street, Door 16 Plattsburgh, NY 12901 Tel.
SAFETY & WARNING INSTRUCTIONS For safety reasons, it is recommended that you read this manual before attempting to operate this appliance. Failure to follow these instructions can result in personal injury or equipment problems. To help recognize note the following symbols: 12. This product shall be connected to a power supply receptacle protected by a ground fault circuit interrupter (GFCI) (electric power washers only). 13.
SAFETY & WARNING INSTRUCTIONS TROUBLE SHOOTING PROBLEM POSSIBLE REASON PRESSURE WASHER WILL NOT START WHEN THE ON/OFF SWITCH IS IN THE "ON" POSITION 1. PUMP DOESN'T REACH ADEQUATE PRESSURE OR CAVITATES 1. 2. 3. 2. 3. 4. Electrical socket is faulty or breaker has tripped. Voltage is inadequate. GFCI has tripped. Power cord is not plugged in. 1. 2. 3. 4. 1.
GETTING TO KNOW YOUR PRESSURE WASHER OPERATING INSTRUCTIONS Storing Your Pressure Washer Ground Fault Circuit Interrupter (GFCI) When you have finished using your pressure washer, follow these steps for safe storage: 1. Turn the pressure washer to the "Off" position. 2. Turn off the water supply. 3. Before disconnecting the high pressure hose connection, point the trigger gun in a safe direction away from you and discharge the high pressure water.
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS Cleaning the Nozzles: If you notice that the output pressure fluctuates, you may have to clean the nozzles. Turn the unit "Off". Unplug from electric outlet and disconnect the water supply. Remove the lance and hose with the trigger gun from unit. Take the small metal pin provided and insert into the nozzle end to remove any obstructions. (Fig.
OPERATING INSTRUCTIONS attributable to air bubbles in the water or other similar phenomena which do not imply the existence of any defects in the machine. Do NOT leave the appliance unattended during the standby for more than 5 minutes. Contrarily, for the safety of the appliance it is necessary to re-turn the On/Off switch to the “Off” position.
