Installation Guide

Securing the RTS5 to the wall
1. Mount the RTS5 to the single-gang box using the provided screws.
2. Mount the Decora® plate onto the RTS5 using the provided screws.
OPERATING THE RTS5
• Pressing the PUSH button once will activate the highest ventilation rate of the HRV / ERV for 20 minutes. Once pressed, the green light will
ash once, and remain on for approximately 20 minutes.
• Pressing the PUSH button twice within a second will activate the highest ventilation rate of the HRV / ERV for 40 minutes. Once pressed, the
green light will ash twice, and remain on for approximately 40 minutes.
• Pressing the PUSH button three times within a second will activate the highest ventilation rate of the HRV / ERV for 60 minutes. Once pressed,
the green light will ash three times, and remain on for approximately 60 minutes.
• Pressing the PUSH button while there’s a steady green light will cancel the timer.
• Once the time expires or if the timer is canceled, the HRV / ERV will return to its normal ventilation capacity, as set on the principal ventilation
control and the green light will turn off.
TROUBLESHOOTING
MOUNTING PLATE
ELECTRICAL BOX
Not included
MACHINE SCREW
Symptom Solution
No light turns on Check polarity of wires
When I press a second, or third time, the light turns off Ensure that your HRV/ERV is listed in the compatibility section of this manual
You must press the button a second or third time less than 1 second after pressing it the
rst time
Fantech reserves the right to modify, at any time and without notice any or all of its products’ features,
designs, components and specications to maintain their technological leadership position
Item #: 406486
Rev Date: 2015-05-12