Install Instructions

The useful service life of the filter media in the HEPA Filtration System is directly related to the volume of air

passed through the system and the amount of contaminants in the air. In a typical residential application, Stage

1 and 2, filters should be replaced every three to six months or when needed. The Stage 3 HEPA filter should

have a life span of two to five years, again, depending on the amount of particulate in the air and the mainte-

nance of the Stage 1 pre-filter.

PAR

TS LIST

STAGE 1 - PRE-FILTER (470142)

STAGE 2 - CARBON FILTER (104654)

STAGE 3 - HEPA FILTER (470140)

MOTOR - (500002)

SERVICE

Stage 1 -

Prefilter

: Air passes through the prefilter where larger particles are taken out of the air.

Stage 2

Carbon

: Air passes through the carbon filter where some gases and odors are removed.

Stage 3 -

HEPA

: Air passes through the certified HEPA media where very small particles are removed.

99.97% of all particles 0.3 microns and larger that pass through this stage are removed.

Particles smaller than 0.3 microns are also removed with less intensity.

If the air flow through your unit is noticeably reduced, you can inspect the HEPA filter by removing

it and seeing if the filter paper is darkened on the inlet or outer side. If it is, the filter cartridge

should be replaced.

Please contact your local Fantech dealer or call HEPA Customer Service at 1.800.747.1762

regarding replacement of filter media, warranty information or if you have any questions or

concerns about the performance of your HEPA Filtration System.