Install Instructions

Note Warning /

Important

note

Information Technical

information

Practical tip

Warnings

DO NOT CONNECT POWER SUPPLY until fan is completely installed. Make sure electrical service to the fan is locked in “Off” position

1. All units are suitable for use with solid-state speed control.

2. This unit has rotating parts and safety precautions should be exercised during installation, operation and maintenance.

3. CAUTION: “For General Ventilation Use Only. Do Not Use To Exhaust Hazardous Or Explosive Materials And Vapors.”

4. WARNING: To reduce the risk of fire, electrical shock, or injury to persons-observe the following:

a. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the factory.

b. Before servicing or cleaning, switch power off at service panel and lock service panel to prevent fan from being switched on accidentally.

c. Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-

rated construction.

d. The combustion airflow needed for safe operation of fuel burning equipment may be affected by this unit's operation. Follow the heating

equipment manufacturer's guidelines and safety standards such as those published by the National Fire Protection Association (NFPA), the

American Society of Heating, Refrigeration, and Air Conditioning Engineers (ASHRAE) and the local code authorities.

e. When cutting or drilling into wall or ceiling, do not damage electrical wires or other hidden utilities.

f. Exhaust fans must always be vented to the outdoors.

g. Acceptable for use over a bathtub or shower.

h. NEVER place a switch where it can be reached from a tub or shower.

5. WARNING! Check voltage at the fan to see if it corresponds to the motor nameplate.

GUARDS MUST BE INSTALLED WHEN FAN IS WITHIN REACH OF PERSONNEL OR WITHIN SEVEN (7) FEET OF WORKING LEVEL OR WHEN

DEEMED ADVISABLE FOR SAFETY.

Read and Save these instructions for future reference.

Not for use with fan/light, heater/fan, or heater/fan/light combination units