Datasheet

-01-
FANTEC SRC-SERIE
STORAGE RACKMOUNT CHASSIS
I. Specification:
Support SAS interface: for 3G backward compatibility.
Support SATA interface: for 3G backward compatibility.
Support hard disk 29pin female SAS and SATA II compatibility.
Support for host card SAS
primary port or SATA II input port.
Support 4 port hard disk inrush current control and mosfet IC for Hot-swapping.
Support hard disk DC +12V, +5V a
nd +3.3V.
Support 4 pcs 0603 SMD blue LED light on for hard disk insert.
(SATA ready is high active, and SAS ready is
low active)
Support 2 pcs power 180 deg big 4-pin D-type connectors.
Support 4 pcs external FAN speed monitoring and FAN failure
buzzer alarm. (Buzzer on board).
Support FAN fail SMD LED active shown and external pin header
.
Support FAN fail buzzer alarm external pin header.
Support external 2X2 pin header for FAN fail LED and mute switch.
Minimum Fan Speed Detection: The FAN IC fail frequency is below 40 Hz,
which corresponds to a fan speed of approximately 1200 rpm.
The fan remains powered during a locked rotor or an under-speed failure condition.
Support miniSAS36 pin host connector for SFF8087 connector
support 4 pcs 0603 white Led light on for hard disk insert
support 4 pcs 0630 red Led light on for hard disk failure indicator.
(connect to Raid contral unit)