Installation Guide

x 10

1/4-20 x 14mm

SCREWS

HARDWARE USED:

Assembling and Mounting the Fan Blades

x 15

FIBER WASHER

3/16-24 x 10 mm

WASHER HEAD

SCREWS

HARDWARE USED:

Figure 17

Blade

Blade Holder

Figure 16

Figure 15

Do not connect fan blades until the fan is completely

installed. Installing the fan with blades assembled

may result in damage to the fan blades.

CAUTION

2. Position the blade over the blade holder with

threaded posts showing. Make sure the bottom edge

of the blade is fully seated against the blade arm.

With a phillips screwdriver, tighten 3/16-24 x 10 mm

washer head screws and fiber washers to secure the

blade to the blade arm. (Figure 16)

NOTE:

Periodically check blade holder hardware and

resecure if necessary.

To reduce the risk of electric shock, disconnect the

electrical supply circuit to the fan before installing

light kit.

CAUTION

To reduce the risk of personal injury, do not bend the

blade holders when installing, balancing the blades

or cleaning the fan. Do not insert foreign objects in

between the rotating blades.

WARNING

3. Secure the blade holders to the motor support

using the 1/4-20 x 14 mm screws throught the holes

located on the side of the motor support. (Figure 17)

1. Remove and discard the motor stops from the motor

assembly by removing the screws. (Figure 15)