Installation Guide
Figure 1
How to Wire Your Ceiling Fan – Rotary Switch
If you feel that you do not have enough electrical wiring
knowledge or experience, have your fan installed by a
licensed electrician.
NOTE: If fan or supply wires are different colors than indicated,
have this unit installed by a qualifi ed electrician.
▲
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1. Run the black, white and green wires through the
wiring hole in the side of the hanger bracket to allow for
electrical connections.
2. Connect the green grounding wire from the fan and
hanger bracket to the grounding wire from the outlet box
(this may be a bare wire or a wire with green insulation).
Securely connect these wires with wire connector
supplied with your fan.
3. Securely connect the white wire from the fan motor
to the white supply (neutral) wire using wire connector
supplied (Figure 1).
4. Securely connect the black fan motor wire to the black
supply wire using wire connector supplied (Figure 1).
5. After connections have been made, turn leads upward
and carefully push leads into the outlet box, with the white
and green leads to one side of the box and the black
leads towards the other side.
120 VAC
Supply
(User
Supplied)
Black Wire
(Hot)
White
(Neutral)
Green Wire
(Ground)
(To/From
hanger
bracket
and fan)
8
How to Hang Your Ceiling Fan (continued)
6. The wires should be spread apart with the grounded
conductor and the equipment-grounding conductor on
one side of the outlet box and the ungrounded conductor
on the other side of the outlet box.
6. Attach the safety cable to ceiling support cable. Slide
cable clamp onto safety cable (from fan). Place the end
of cable through the loop of ceiling support cable. Pull as
much cable through loop as possible. Feed end of cable
into clamp hole and fi rmly tighten screw (Figure 5). Cut
off excess safety cable.
▲
WARNING
To avoid possible shock, do not pinch wires between the
downrod and the hanger bracket.
NOTE: Supply wires and
fan wires omitted for clarity
Figure 5
Attach
Safety Cable
to Ceiling
Support
Cable