Installation Guide
Figure 2
Figure 3
Downrod
(Assembled Fan)
Junction
Box
Ceiling
Support
Cable
Ceiling Joist
Wood Member
(2” x 4” Approx.)
Hanger Bracket
Ceiling
No
less than
7 ft
2 ft min.
from
staircase
or wall
WARNING:
Do NOT
Mount Fan
On Wall
Or Floor!
Floor
Ceiling
7
How to Hang Your Ceiling Fan
Figure 1
▲
WARNING
The fan must be hung with at least 7´ of clearance from
floor to blade and MUST ONLY be hung in a vertical
downward position from ceiling. (Figure 1)
▲
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before hanging.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1. Attaching Ceiling Support Cable (Figure 2): Drill
¼˝ pilot hole through into the ceiling joist or structural
member. Securely attach the ceiling support cable with
3
⁄8˝ x 2˝ lag bolt and fl at washer.
NOTE: Ceiling support cable must be directly secured to
ceiling joist or structural member between fl at washer and
junction box with 2˝ lag bolt (Figure 2).
2.
Hanger Bracket Attachment:
Securely attach the hanger bracket to the outlet box using
the outlet box screws and washers supplied with the outlet
box (Figure 2).
3. Assemble and secure the assembled fan with hex-
head bolt, two lockwashers, nylon locknut and clevis pin.
(Figure 3)
CAUTION
To Reduce the Risk of Personal Injury, this Product Must
be Secured as Described in the Manual.
4. (Optional)
Sloped Ceiling Installation (Figure 4)
:
Loosen two nuts located on both sides of the hanger
bracket to orientate the downrod in the vertical position.
5. Make sure the electrical supply wires, including the
hanger bracket grounding wire and safety cable are
pulled through the downrod, between the hanger bracket
and the junction box so that electrical connections can be
made later.
INSTALLATION NOTE
The hanger bracket angle adjustment MUST ONLY be
used to orientate the downrod in a vertical downward
position.
▲
WARNING
It is critical that the clevis pin and lock nut in the hanger
bracket/downrod area is properly installed. Failure to
verify that the nut and hairpin clip are properly installed
could result in the fan falling.
Figure 4
Loosen Nuts on
both sides of the
Hanger Bracket
Sloped
Ceiling