Owner Manual

11
How to Install Your Canopy Housing
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
NOTE: This step is applicable after the neccessary wiring
is completed.
Ceiling Canopy
Canopy Screw
Cover
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
Figure 1
Figure 2
How to Assemble Your Ceiling Fan Blades
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
1. Secure the blades to the motor assembly using
the 3/16˝-24 screws and fiber washers. (Figure 1)
Figure 1
Figure 2
x 6
x 6
FIBER WASHER
3/16˝-24
WASHER HEAD
SCREWS
HARDWARE USED:
3/16˝-24 Waher Head Screw
and Fiber Washer
(3 each per blade)
Blade
Motor
Assembly
NOTE: Periodically check blade hardware and
resecure if necessary.
Motor Assembly
2. Remove six screws from the motor and retain
the screws for later. (Figure 2)