Owner Manual

Assembling and Mounting the Fan Blades

Blade

Blade Holder

Arm

Figure 14

Figure 15

x 10

1/4-20 x 14mm

SCREWS

HARDWARE USED:

x 15

FLAT WASHER

3/16-24 x 7.5mm

PHILLIPS HEAD

SCREWS

HARDWARE USED:

Do not connect fan blades until the fan is completely

installed. Installing the fan with blades assembled

may result in damage to the fan blades.

CAUTION

1. Position the blade over the blade holder with

threaded posts showing. Make sure the bottom edge

of the blade is fully seated against the blade arm.

With a phillips screwdriver, tighten 3/16-24 x 7.5 mm

phillips head screws and flat washers to secure the

blade to the blade arm. (Figure 14)

To reduce the risk of personal injury, do not bend the

blade holders when installing, balancing the blades

or cleaning the fan. Do not insert foreign objects in

between the rotating blades.

WARNING

2. Secure the blade holders to the motor support

using the 1/4-20 x 14 mm screws throught the holes

located on the side of the motor support. (Figure 15)

NOTE:

Periodically check blade holder hardware and

resecure if necessary.