Owner Manual

How to Assemble Your Light Kit or Cap (continued)
14
3. Remove the three screws in the light kit and
retain the screws for later. (Figure 3)
4. If installing the light kit, skip this step.
Assemble the light kit wire cover to the light kit using
the previously removed screws and secure all three
screws.
(Figure 4)
Light Kit
Light Kit
Wire Cover
Figure 3
Light Kit
Light Kit
Figure 4
Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 5A)
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
5A. For use with light kit.
5B. For use with steel cap.
If you want to install the steel cap and not the light kit.
Assemble the steel cap to the light kit by twisting in
a clockwise direction. (Figure 5B)
NOTE: If you have installed your fan with the steel
cap, skip Steps 6 and 7.
LED Assembly
Steel Cap
6. Assemble the LED assembly to the light kit using
the previously removed screws and secure all three
screws. (Figure 6)
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
CAUTION
Figure 7
Light Kit
Glass
Light Kit
LED Assembly
Figure 6
7. Secure the glass to light kit by twisting in a
clockwise direction. Twist the glass gradually
until it
snaps onto the light kit. Do not over-tighten.
(Figure 7)
Figure 5A Figure 5B