Installation & Assembly

I
I I
I I I
I
I
V
V
V
3. The remote buttons instruct as below:
I = minimum speed II = low speed
III = medium low speed IV = medium speed
V = medium high speed VI = high speed
Button:
This button turns the fan off.
Reverse button (back of remote):
This button is to control fan direction.
(Figure 4).
Fan speed:
Down Light button:
The button is to control light, Infinite light levels
are available by holding the light on/off button
Up Light button /
Figure 4
4. “D” and “ON” dip switch:
The “ON” selection is the light dimmable selection and is
to be used with all bulbs other than CFL. The “D”
selection is the light on only (no dimming function) and
is to be used with CFL bulbs (as CFL bulbs cannot be
dimmed). The receiver provides the following protective
function: (Figure 5)
Lock position: The DC motor has a built-in safety feature
against blade obstruction against obstruction during
operation. If something obstructs the fan blades the
motor will stop operating after 30 seconds of
interruption. Please remove obstacles and reset.
Over 80W protection: When the receiver detects motor
power consumption which is greater than 80W, the
receiver power will shut down and fan operation will
cease. Disconnect the power supply and after 5
seconds return power on to the fan.
Copyright 2017 Fanimation
2017/08 V.01
10983 Bennett Parkway
Zionsville, IN 46077
[phone] • FAX [phone]
Outside U.S. call [phone]
Visit Our Website @ www.fanimation.com
Figure 5