Installation Guide

How to Operate Your Ceiling Fan (continued)
Figure 7
Maintenance
1. ylnoehtsinafgniliecwenruoyfogninaelccidoireP
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth
.hsinif ehtgnihctarcsdiovaot
Abrasive cleaning agents are not required and should
be avoided to prevent damage to finish.
CAUTION
Do not use solvents when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of electrical shock.
RECOMENDED: Periodically check that the blade holders to motor hub screws are secure and tight.
How to Clean Your Ceiling Fan Blades
Periodic light dusting of the blades is recommended.
A feather duster will work best.
Avoid using water, cleansers, or harsh rags, which can
warp and ruin the blades.
16
9. If you have encountered an issue during the set up
process, you can follow the below procedure to clean
the memory code of your handheld remote: (Figure 7)
1) Turn the wall switch that controls the power to the
fan to the o position, or the breaker that controls the
power to the fan to the o position.
2) Turn the wall switch that controls the power to the
fan to the on position, or the breaker that controls the
power to the fan to the on position.
3) Press the “SET” button inside of the battery com-
partment of the handheld remote control WITHIN 60
seconds of restoring power to the fan.
4) Pressing the “SET” button for 5 seconds will indicate
if the fan is programmed to the remote control in hand.
5) The light will turn on and o twice – this indicates
that the fan has learned the code of the handheld you
are holding.
6) Pressing the “SET” button for 10 seconds or more
will start the code clearing process. The fan will
backward and forward, the light will turn on and o
twice.
7) This will indicate that the fans and handheld remotes
have cleared their memory codes.
8) Please note in order for the memory codes to be
cleared, you must hold the set button for 10 seconds or
longer.