Installation Guide
4
How to Assemble Your Floor Fan
x 12
3/16"-24 x 1/2"
CAP HEAD WITH
SPRING WASHER
HARDWARE USED:
Motor Assembly
Leg
1. Assemble the leg to the motor assembly
with 3/16Ë-24 x 1/2Ë screws.
Make sure all screws securing tight the leg
with motor assembly using the supplied âTâ
wrench. (Figure 1)
4. Select the desired airflow, located on back of motor
assembly by rotating switch clockwise. (Figure 4)
3. You have now completed the assemby of your
fan. Plug cord directly into the socket. (Figure 3)
Figure 3
Cap Rubber
2. Assemble the cap rubber on to the screw of
the leg. (Figure 2)
Figure 2
Rotating Switch
Figure 4
Figure 1