User manual

Figure 2

Figure 3

NOTE: Supply wires and fan wires

omitted for clarity.

2. Operating & Using Wall Control (Figure 3):

NOTE: You can now use your speed control to select any

of the 4-speeds plus OFF.

• 4

Position – low fan speed

• 3

Position – low medium fan speed

• 2

Position – medium fan speed

• 1

Position – high fan speed

• OFF Position – fan off

▲

WARNING

Check to see that all connections are tight, including

ground, and that no bare wire is visible at the wire

connectors, except for the ground wire. Do not operate

fan until the blades are in place. Noise and fan damage

could result.

Installing the Canopy Housing

Figure 1a Figure 1b

NOTE: This step is applicable after the necessary wiring

is completed.

▲

WARNING

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the canopy housing

and not pinched between the housing and the ceiling.

1. Loosen the two shoulder screws in the Hanger

Bracket.

2. Securely attach the Canopy Housing over the shoulder

screws (Figure 1a).

3. Securely attach and tighten the Canopy Screw Cover

over the shoulder screws in the Hanger Bracket utilizing

the keyslot twist-lock feature (Figure 1b).

How to Wire and Operate Your CW40-220 Wall Control (cont’d)

▲

WARNING

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the outlet box and

not pinched between the wall plate and the wall.