Owner Manual

How to Wire Your Ceiling Fan
Main Fuse Box
Figure 2
Figure 3
x 6
Wire
Connectors
HARDWARE USED:
Bl
ue to
Li
g
ht
Bl
ac
k t
o
M
o
t
or
W
hit
e
t
o
M
o
t
or
all
NOTE: The remote unit has 32 different code
combinations. To prevent possible interference from
or to other remote units, simply change the
combination code in the remote and receiver.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
CAUTION: INCORRECT WIRE CONNECTION WILL
DAMAGE THIS RECEIVER.
1. To set the code on receiver unit, slide dip switches
to the same positions as set on the remote. (Figure 1)
NOTE: Factory setting is all up. Do not use this
position.
2. Slide the receiver into the hanger bracket. Connect
green wires from hanger bracket and downrod to bare
(ground) wire using wire connector. Connect black
wire from receiver unit marked “AC IN L” to black
supply wire using wire connector. Connect white wire
from receiver unit marked “AC IN N” to white supply
wire using wire connector. Connect white wire from
receiver unit marked “TO MOTOR N” to white wire
from fan using wire connector supplied with receiver
unit. Connect black wire from receiver unit marked
“TO MOTOR L” to black wire from fan using wire
connector supplied with receiver unit. Lastly, connect
blue wire from receiver unit to the blue fan light wire
using wire connector supplied with receiver unit.
(Figure 3)
NOTE: If you feel that you do not have enough
electrical wiring knowledge or experience, have your
fan installed by a licensed electrician.
WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring.
(Figure 2)
WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors except for the ground wire. Do not operate
fan until the blades are in place. Noise and motor
damage could result.
Figure 4
Green Wire
from Supply
(Ground)
White Wire
from Supply
White Wire
from Receiver
Green Wire
from Hanger
Bracket (Ground)
Green Wire
from Hanger
Ball (Ground)
Listed
Outlet Box
Household
Supply
Black Wire
from Supply
Black Wire
from Receiver
Receiver
3. After connections have been made, turn leads
upward and carefully push leads into the outlet box,
with the white and green leads to one side of the box
and the black leads to the other side. (Figure 4)
Figure 1
Dip Switch
Receiver
Remote Control
ON DIP
1 2 3 4 5
10