Installation Guide

Downrod
Set Screw
Hanger Ball
7
How to Assemble Your Ceiling Fan
Set Screws (2)
Figure 1
Figure 2
Figure 3
Downrod
Downrod
2. Remove the hairpin clip and clevis pin from the
bottom of the downrod. Retain the pin and clip for
reinstallation in Step 4. (Figure 2)
Set Screws and
Locking Nuts (2)
Clevis Pin
Hairpin Clip
4. Thread downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. Securely
tighten the set screws with screwdriver then fully
tighten the nuts by hex wrench. (Figure 4)
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in
the fan falling.
5. Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 5)
Motor Coupling
Cover
Ceiling Canopy
Canopy Screw
Cover
Hairpin
Clip
Clevis Pin
Figure 4
Figure 5
1. Remove the hanger ball portion from the downrod/
hanger ball assembly by loosening the set screw in the
hanger ball until the ball falls freely down the downrod.
Remove the pin from the downrod, then remove the
hanger ball. Retain the pin and hanger ball for reinstalla-
tion in Step 6. (Figure 1)
3. Loosen the two set screws and locking nuts in
the downrod support of the motor assembly. Route
the brown, blue, red, gray and yellow wires through
the downrod. (Figure 3)
Brown, Blue, Red,
Gray and Yellow wires