Installation Guide

3. Remove one of the three screws in the light plate
assembly. Retain the screw for later and slightly
loosen the remaining two screws. (Figure 3)
Figure 4
Figure 5A
4. If installing the light kit, skip this step.
Assemble the light kit wire cover to the light plate
assembly using the two key slots. Replace the
removed screw and secure all three screws.
(Figure 4)
Figure 3
Figure 5B
Connect the 2 single pin connectors from the LED
assembly to the 2 single pin connectors from motor
assembly. (Figure 5A)
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
5A. For use with light kit.
5B. For use with steel cap.
If you want to install the steel cap and not the light
kit. Assemble the steel cap to the light
plate assembly
by twisting in a clockwise direction. (Figure 5B)
NOTE: If you have installed your fan with the steel
cap, skip Steps 6 and 7.
Light Kit
Wire Cover
LED
Assembly
Steel Cap
13
How to Assemble Your Light Kit or Cap (continued)
Figure 6
Figure 7
7. Secure the light shade to light plate assembly by
twisting in a clockwise direction. Do not over-tighten.
(Figure 7)
6. Assemble the LED assembly to the light plate
assembly using the two key slots. Replace the
removed screw from Step 3 and secure all three
screws. (Figure 6)
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
CAUTION
LED Assembly
Light shade
Light Plate
Assembly
Light Plate
Assembly
Light Plate
Assembly
Light Plate
Assembly
Light Plate
Assembly