Installation Guide

4. Once the connection has been made, slide the
receiver into the hanger bracket, taking care not to
pinch the wires. (Figure 5)
Receiver
Hanger Bracket
How to Wire Your Ceiling Fan (continued)
Figure 5
Figure 1
11
How to Install Your Canopy Housing
How to Assemble Your Ceiling Fan Blades
2. Securely attach and tighten the canopy screw
cover over the shoulder screws in the hanger bracket
utilizing the keyslot twist-lock feature. (Figure 1b)
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1a)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
NOTE: This step is applicable after the neccessary wiring is completed.
Figure 1a Figure 1b
Canopy
Canopy Screw
Cover
1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom edge
of the blade is fully seated against the blade holder.
:LWKDVFUHZGULYHUWLJKWHQÝVHUUDWHGKHDG
screws and flat washers to secure the blade to
the blade holder. (Figure 1)
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
x 12
x 12
Flat WASHER
HARDWARE USED:
Blade
Blade Holder
Ý6HUUDWHG+HDG
Screw with Flat Washer
SHUEODGH
ß
SERRATED HEAD
SCREWS